Differences

This shows you the differences between two versions of the page.

--- disaggregation_of_yield_and_irrigation [2020/03/29 08:20] – [Data preparation (disyield.gms)] matsz
+++ disaggregation_of_yield_and_irrigation [2020/03/29 08:22] – [Data preparation (disyield.gms)] matsz
@@ Line 164: / Line 164: @@
 \begin{equation}
-y_{h,p,y}= \sum_g \{f_{h,g} \cdot y_{g,p,y} /} \sum_g \{f_{h,g}\}
+y_{h,p,y}= \sum_g \{ f_{h,g} \cdot y_{g,p,y} \} \sum_g \{ f_{h,g} \}
 \end{equation}
-\(y_{h,p,y}\)	Yields simulated with PESETA [parameter, kg/ha] on PESETA grid //g// and for PESETA crop //p// under water limited and potential conditions \(y \in \{wyl,relpy\}\). \\
+\(y_{h,p,y}\)	= Yields simulated with PESETA [parameter, kg/ha] on PESETA grid //g// and for PESETA crop //p// under water limited and potential conditions \(y \in \{wyl,relpy\}\). \\
-\(f_{h,g}\)	Fraction of spatial unit //h// in PESETA grid //g// [parameter, dimensionless]. The sum of \(f_{h,g}\)  over all spatial units //h// gives 1 unless a few occasions where spatial inaccuracies leave small shares of a spatial unit outside the land area covered by the PESETA grid.
+\(f_{h,g}\)	= Fraction of spatial unit //h// in PESETA grid //g// [parameter, dimensionless]. The sum of \(f_{h,g}\) = over all spatial units //h// gives 1 unless a few occasions where spatial inaccuracies leave small shares of a spatial unit outside the land area covered by the PESETA grid.
 (iv) Calculation of relative water limited yield per spatial unit
@@ Line 176: / Line 176: @@
 \end{equation}
-\(r_{h,c}^{wly}\)	Relative water limited yield [parameter, dimensionless] of PESETA crop //p// in spatial unit //h//.
+\(r_{h,c}^{wly}\) =	Relative water limited yield [parameter, dimensionless] of PESETA crop //p// in spatial unit //h//. \\
-\(y_{h,p}^{wly}\)	Water limited yield [parameter, kg/ha] of PESETA crop //p// in spatial unit //h//
+\(y_{h,p}^{wly}\) =	Water limited yield [parameter, kg/ha] of PESETA crop //p// in spatial unit //h// \\
-\(\overline{y_{h,p}^{wly}}\)	Averge water limited yield [parameter, kg/ha] of PESETA crop //p// over all spatial units //h// in region //r//
+\(\overline{y_{h,p}^{wly}}\)	 =Averge water limited yield [parameter, kg/ha] of PESETA crop //p// over all spatial units //h// in region //r//
 If the water limited yield for a PESETA crop is missing for a spatial unit, but available in other spatial units in the same region, the area-weighted water limited yield for the PESETA crop over the region is assigned to the spatial unit.