capdis_module_gui_basics
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
capdis_module_gui_basics [2020/03/28 07:28] – created matsz | capdis_module_gui_basics [2022/11/07 10:23] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
=====CAPDIS module – GUI basics===== | =====CAPDIS module – GUI basics===== | ||
- | Files: | + | Files: |
- | %curdir%/ | + | |
- | %curdir%/ | + | |
+ | %curdir%/ | ||
The distribution of crop shares, livestock numbers, yield and nitrogen flows is a sequential process of a number of sequential steps (CAPRI tasks). The distribution of land use and livestock numbers, yield and irrigation shares in each step is based on the results of the previous step which is used as priors. | The distribution of crop shares, livestock numbers, yield and nitrogen flows is a sequential process of a number of sequential steps (CAPRI tasks). The distribution of land use and livestock numbers, yield and irrigation shares in each step is based on the results of the previous step which is used as priors. | ||
Line 15: | Line 17: | ||
__Baseline and scenarios (mode: CAPMOD)__: results from the CAPREG disaggregation are used as priors for the ex-ante simulation results | __Baseline and scenarios (mode: CAPMOD)__: results from the CAPREG disaggregation are used as priors for the ex-ante simulation results | ||
+ | The disaggregation module works at the level of CAPRI NUTS2 regions, which are run in parallel mode. The number of parallel instances depends on the computing capacity (check CAPRI settings, tab ‘GAMS and R’, Number obtained from ‘Get the number of processors …’ or written into the combo box). To combine result files at regional level into country-level result files, a CAPRI task ‘Collect disaggregation results’ is available. This can be done for results of all other CAPRI disaggregation tasks. Optionally, a new country file can be generated (overwriting previous results) or an existing country file updated (overwriting only the data of the ‘new’ NUTS2 results). Also the NUTS2 files can be deleted. | ||
+ | |||
+ | **Figure 42: Sequential disaggregation of land use** | ||
+ | |||
+ | {{:: | ||
+ | |||
+ | {{:: | ||
+ | |||
+ | To activate CAPDIS (disaggregation module), select the CAPRI workstep “Disaggregate Results”. Then select one of the following CAPRI tasks: A priori land use distribution, | ||
+ | |||
+ | {{: | ||
+ | {{: |
capdis_module_gui_basics.1585380538.txt.gz · Last modified: 2022/11/07 10:23 (external edit)